Autel TPMS Sensor 2 in 1(315MHz + 433MHz) Clamp-in Rubber Valves Programmable Sensors Tire Pressure Monitoring System (4 Pieces) (Red)


SKU: 51054053 Category:


Autel TPMS Sensor 2 in 1(315MHz + 433MHz) Clamp-in Rubber Valves Programmable Sensors Tire Pressure Monitoring System (4 Pieces) (Red). 315 + 433MHz FEATURE: Only 1 Sensor to service nearly every TPMS equipped vehicle to lower repair cost and to have higher install efficiency with no relearning required. The MX-Sensor is 100% cloneable with the original sensor ID and put in the same position. 98% COVERAGE: Featuring the latest and most comprehensive coverage of 98% OE sensors on the market, and up to 90% of North American, European and Asian vehicles, it nearly fits all types of wheels on the road. EASY TO USE: The maximum sensor signal strength allows sensors to be easily programmed wirelessly even when they have already been mounted to the wheel.(Note: the sensor must be use Autel TPMS tool to program). Moreover, the unique PRESS release valve design makes the manual sensor replacement much easier. SOLID DURABLE: It is equipped with an automotive grade battery to meet severe weather conditions, being able to withstand cold, hot. And featuring a high-precision air valve to prevent air leakage, this sensor ensures superior stability and performance. WARRANTY: Autel guarantees that the sensor is free from material and manufacturing defects for a period of 24 months or for 24,000 miles. Each sensor is marked with a serial number to track the sensor quality from the factory to ensure that only the highest quality parts are installed. Installation Process Loosen the tire: Remove the valve cap and core and deflate the tire. Dismount the tire: Clamp the tire onto the tire changer, and adjust the valve at 1 oclock relative to the tire separation head. Insert the tire tool and lift the tire bead onto the mounting head to discount the head. Dismount the sensor: With a screwdriver remove the fastening screw and sensor from the Valve stem, then loosen the nut and remove the valve. Mount sensor and valve: Slide the valve stem through the valve hole of the rim. Tighten the screw-nut with 4.0 Nm with the help of the positioning pin. Assemble the sensor body against the rim and tighten the screw. Mount the tire: Place the tire on the rim, making sure that the valve faces the separation head at an angle of 180 degrees. Mount the tire over the rim. While we aim to supply accurate product information, it is sourced by manufacturers, suppliers and marketplace sellers, and has not been provided by Overstock.